SCSI(7) — Special Files
Digital
NAME
SCSI − Small Computer System Interconnect
DESCRIPTION
The operating system interfaces to disk and tape devices through the Small Computer System Interconnect (SCSI). Initial SCSI support is limited to the Digital-supplied mass storage devices. The following devices are fully supported on the operating system:
•Winchester disks: RZ22, RZ23, RZ23L, RZ24, RZ25, RZ55, RZ56, RZ57, RZ58, RX23, RX26, RX33
•Magnetic tapes: TZ30, TZK50, TLZ04, TSZ05, TKZ08, TZK10
•Optical disks: RRD40, RRD42
Under the operating system, a SCSI device is referred to by its logical name. Logical names take the following form:
nn#
The nn argument is the two-character name; the number sign (#) represents the unit number. The two character names for SCSI devices are:
rz- RZ22, RZ23, RZ23L, RZ24, RZ25, RZ55, RZ56, RZ57, RZ58, RX23, RX26, RX33, RRD40, RRD42 disks
tz- TZ30, TZK50, TLZ04, TSZ05, TKZ08, and TZK10 tapes
The unit number is a combination of the SCSI bus number, either 0, 1, ... and the device’s target ID number. The unit number is eight times the bus number plus the target ID. For example, an RZ23 disk at target ID 3 on bus 0 would be referred to as rz3; a TZK50 tape at target ID 5 on the second SCSI bus would be referred to as 13.
The SCSI bus has eight possible target device IDs. By default, one is allocated to the system. This allows for a maximum of seven target devices connected to a SCSI bus.
RESTRICTIONS
The SCSI device driver does not operate with optical disks, other than the Digital-supplied devices.
The SCSI driver attempts to support on a best effort basis, non-Digital-supplied winchester disks and magnetic tapes.
The following notes apply to the driver’s handling of non-Digital-supplied disks:
•These disks are assigned a device type of RZxx, instead of Digital-supplied disk names listed above (i.e., RZ23L, RZ24, etc). The RZxx disks follow the same logical device naming scheme as the Digital-supplied disks.
•During the autoconfigure phase of the system startup, the driver prints the contents of the SCSI vendor ID, product ID, and the revision level fields of the inquiry data return by the SCSI device.
•RZxx disks are assigned a default partition table. The default table can be modified by editing the sz_rzxx_sizes[8] entry in the file /usr/sys/data/scsi_data.c. The disklabel utility can also be used to modify the partition table on a RZxx disk.
•The only logical unit number (LUN) supported for each target ID is 0.