Prompts by "DEVICE>" and accepts UNIBUS device names.
  Output is the set of CSR and vector addresses that AUTOCONFIGURE will
  use.

  Form of input:

                device[,n[,p]]  (Default n = 1, p = 0)

          where

          n        is the number of devices on the UNIBUS being
                   configured

          p        is the optional number of devices on all previous
                   UNIBUS in a multiple UNIBUS system. Note that "p"
                   affects only the device names, not the addresses
                   generated.

Additional information available:

Qualifiers

Additional information available:

/INPUT/OUTPUT/NORESET

 /INPUT = <file-spec>

  Specifies where input is to be read from. The default is SYS$INPUT.

 /OUTPUT = <file-spec>

  Specifies where output is to be written to. The default is SYS$OUTPUT.

 /NORESET

  For use on multiple UNIBUS systems.  Used on subsequent CONFIGURE
  commands to keep controller names from being reset. The second
  input parameter is unnecessary.