.edt_swapp(0)                       CLIX                       .edt_swapp(0)



  NAME

    .edt_swapp - Software application file

  DESCRIPTION

    The .edt_swapp file is read by filledt on its second pass during the
    self-configuration process to rename specified Equipped Device Table (EDT)
    entries.  The file has the following format:

    slot     swname     hwname
         ...
    FF

    The number in the slot field specifies the entry in the EDT to be updated.
    The swname column contains the new name which will be associated with this
    board.  The hwname field contains the name with which the board was
    associated generically.  The last line contains FF for the slot number to
    signal the end of the data to the firmware.  This file can be displayed by
    the editsa -l command.

  CAUTIONS

    This file is not to be edited directly.  It may only be Updated through
    editsa.

  RELATED INFORMATION

    Commands:  editsa(1), filledt(8)

























  2/94 - Intergraph Corporation                                              1